Technical Notes / Engineering Guide

Engineering Guide: CNC Machining of Flanges with Precision Bolt Patterns

Plan the datum, machining setup and inspection for a CNC-machined flange with a bolt pattern, pilot and seating face.

Start with the locating features

Determine whether the pilot diameter or the fasteners locate the flange. On a pilot-located flange, specify how the bolt pattern is positioned relative to the pilot and seating face. Clearance holes alone cannot compensate for a misaligned pilot.

Preserve the datum during drilling

Turn the seating face and locating diameter from a common setup when feasible. If a second operation is necessary, seat the flange on the functional face, pick up the pilot and verify seating before drilling. Thin flanges can dish under clamping, so check the face again after release.

Inspect the interface as a system

Check the pilot, the seating face and the hole pattern relative to the drawing datum. Measure or functionally check the pattern using the agreed datum setup. After deburring or finishing, verify that chamfers, coatings and raised edges do not prevent seating.

Related engineering resources

See the RFQ process

Request a Quote
Request a Quote